Tag: IC693MDL753H

Brand GE Fanuc
Series Series 90-30
Manufacturer GE Fanuc; Emerson Automation (Current) Emerson Automation (current)
Series Series 90-30
Part number IC693MDL753
Product description Discrete output module
Product description Discrete output module
Product Type Digital I/O
Number of channels 32 (32)
Nooooo. Number of output groups four (4)
Compatibility GE Fanuc 90-30 Programmable controllers
Nooooo. Group number four (4)
Number of channels per group 8 (8)

The IC693MDL753 is a digital output module of the 90-30 series Programmable Logic Controller (PLC) series. The module has thirty-two (32) positive logic output channels that produce an output voltage range of 102-28.8 with a nominal voltage of 12-24 VDC. The IC693MDL753 was previously manufactured by GE Fanuc Automation and has now been acquired by Emerson Automation. The module specifically comes with output groupings, four (4) groups of eight (8) outputs each. Each output group has 250 V and 100 V isolation or optical isolation between the field side and the logical side. The IC693MDL753 has an output current rating of 0.5 amps per point, with a maximum of 4 amps per group and 3 amps per group of common pins. It produces a surge current of 5.4 amps for 10 ms, while the on-voltage drops to 0.3 VDC. The Off state leakage current is 0.1 mA, while the On and Off response times, typical for both signal transitions, are 0.5 ms. The IC693MDL753 has an internal power consumption of 260 mA from the 5-VDC backplane. The IC693MDL753 is compatible as both local and distributed I/O modules. It can be installed in any available slot in the chassis, except for specified CPU, communication adapter, and dedicated module slots. The IC693MDL753 occupies one slot and can be installed as many times as needed, limited by the host controller’s I/O capacity and memory. To connect electrical loads to this discrete output module, the IC693CBL315 recommended manufacturer’s cable assembly.

The IC693MDL753 I/O module is a 32-point digital I/O module. The IC693MDL753 I/O module was developed by GE Fanuc for the 90-30 series of GE programmable logic controllers or PLCS. When using the 5-volt DC voltage supplied by the PLC backplane, the module has a peak current consumption rating of 260 mA. When each output point is ON, it consumes 16 mA of current, and the LED indicator at each output point consumes 4.7 mA of current. The 32 points were divided into 4 groups with 8 outputs per group. When operating at 24 volts DC, each set of points consumes 16.5 milliamps of current when all eight outputs in the group are ON. When operating at 12 volts DC, each group consumes 9.6 mah of current when all eight outputs in the group are on. The inrush current of the IC693MDL753 I/O module is 5.4 amps. Both the on-response time and off-response time have a maximum value of 0.5 ms. The maximum output current of each point is 0.5 amps, and the maximum output current of each group is 4 amps. The output voltage range of the IC693MDL753 I/O module is 10.2 to 28.8 volts DC. The output on the module is positive logic output. The output switches the load of the positive terminal of the power supply and provides current to the load. Each set of output points can be used for different loads. The optocoupler provides isolation between the logical side and the field side of the IC693MDL753 I/O module. When the PLC’s CPU stops, all module outputs are forced into the OFF state. The output circuit is connected via two 24-pin male connectors on the front of the module.